Scilox BL100 Manual de usuario descargar pdf (Pagina 16)

BL100 User Manual

- 9 -

2.3 Enroll an Ordinary User

Note: You must change the MPC and enroll an Administrator User first;

otherwise you can't enroll any Ordinary Users.

2.3.1 Enroll an Ordinary User’s Fingerprint

1. Press button to start the deadbolt and enter the “Verify State”.

2. There are two methods to enter the “Management Mode”:

(1) Press and hold the button until you hear 1 long beep, enter the

5-digit MPC, and then press button to enter the “Management

Mode”.

(2) Verify the registered Administrator's PIN code or fingerprint (please see2.4

User Verification) to enter the “Management Mode”.

3. Press "1" to enter the Enroll Ordinary User's Fingerprint Mode.

4. Enter a 3 digit User ID, then press button to confirm.

Note: The Ordinary Users' ID must be between "001" and "994".

5. Place finger on the fingerprint sensor properly (For details, see 1.5 Finger

Placement), and repeat it three times, until you hear one long beep and LED flashes

green.

Note:

(1) If deadbolt fails to register, the deadbolt will give 2 short beeps and the LED

will flash red. If the deadbolt failed to register, you can try again for two more

times.

(2) If the deadbolt registers successfully, it will automatically exit the Enroll

Administrator User mode.

(3) You can press and hold "0" key to cancel operation and exit anytime.

(4) If you want to enroll more Administrator Users, then repeat steps 1-5.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

Sin comentarios

Scilox BL100 Manual de usuario Pagina 16